Wyse WES2009 2GF/1GR hardware/software Przewodnik Instalacji Strona 9

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 8
Installing Flash and RAM 5
Step 2: Install the Flash Module
Warning
Flash modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis
and keep that contact with the chassis during the installation process.
1. Note where the connector of the flash module is located in Figure 4. Remove the
existing flash module from the socket.
Figure 4 Removing the existing flash module
2. Install the new flash module in the reverse order of removing the original flash module
making sure to align the plastic tab of the module’s connector with the notch in the
connector on the board.
Step 3: Install the RAM Module
Warning
RAM modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis
and keep that contact with the chassis during the installation process.
1. Note where the connector of the RAM module is located in Figure 5. Remove the
existing RAM module. Use your fingers to unlock the two retaining clips at either side of
the RAM module by pushing in the direction of the arrows shown in Figure 5. The
module should pop up from its socket. Lift out the RAM module.
Figure 5 Removing the existing RAM module
Przeglądanie stron 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Komentarze do niniejszej Instrukcji

Brak uwag