Wyse WES2009 2GF/1GR hardware/software Przewodnik Instalacji Pobierz pdf (Strona 8)

4 Chapter 2

Procedures

Step 1: Remove the Top Cover

Caution

Follow all precautions listed in the Quick-Start Guide that came with your

cloud client for disconnecting and reconnecting the cloud client.

1. Perform a proper shutdown of the cloud client by closing all files and ending your

session, and then press the power button to turn off the cloud client.

2. Unplug the power cord and power adapter, remove all of the cables from the rear of the

cloud client, and then detach any vertical foot.

3. Position the cloud client horizontally, remove the two screws from the rear of the cloud

client using a small Phillips screwdriver.

Figure 2 Removing the rear screws

4. Remove the top cover from the cloud client by inserting the tip of a small Flat-Edge

Screwdriver just inside the edge of the lock receptacle to make contact with the metal

liner that lines the opening. Apply pressure inward and downward on the metal liner

while pulling up on the plastic housing until it releases as shown in Figure 3.

Figure 3 Removing the top cover

5. Lift the top cover to remove it and expose the main board as shown in Figure 4. Notice

that the rear of the cloud client is positioned at the bottom of the photo.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Brak uwag

Wyse WES2009 2GF/1GR hardware/software Przewodnik Instalacji Strona 8